Pioneer A-A9-J - Manual (Page 15)

Other connections 05
15
En
English
Français
Deutsch
Nederlands
Italiano
Español
Important
If you have followed the steps above, and still
can’t hear any audio output, try the following:
• Switch the amplifier off, then on again.
• Selecting another input source (like CD or
TAPE), then back to USB.
Caution
• Make sure you don’t switch off the
computer or unplug the USB cable during
playback.
• To prevent noise being output, don’t use
other software on your computer during
playback.
• Pioneer is not responsible for computer
system damage, software crashes or
failures, or any other possible computer
problems due to this configuration.
Microsoft
®
, Windows
®
XP, Windows
®
2000, Windows
®
Millennium Edition, Windows
®
98, and Windows NT
®
are
either registered trademarks or trademarks of Microsoft
Corporation in the United States and/or other countries.
Connecting an additional
amplifier
This amplifier has more than enough power for
any home use, but it’s possible to add an
additional amplifier using the pre-outs. Make
the connections shown below to add an
amplifier to power your speakers.
• Before making or changing the
connections, switch off the power and
disconnect the power cord from the AC
outlet.
PRE
OUT TAPE TUNER AUX CD PHONO
MM/MC
L
R
GND
L
R
USB
AUDIO IN
SIGNAL
CONTROL
OUT
IN
PLAY
OUT
REC
INPUT
R L
ANALOG
This amplifier
Stereo amplifier
A9_MY.book Page 15 Tuesday, October 10, 2006 10:40 AM