Philips HK-1032-DS8550 - Manual (Page 4)

5
m Refer all servicing to qualified service personnel. Servicing is
required when the apparatus has been damaged in any way, such
as power-supply cord or plug is damaged, liquid has been spilled
or objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has
been dropped.
n Battery usage CAUTION – To prevent battery leakage which may
result in bodily injury, property damage, or damage to the unit,the
batteries (battery pack or batteries installed) shall not be exposed
to excessive heat such as sunshine, fire or the like.
o Apparatus shall not be exposed to dripping or splashing.
p Do not place any sources of danger on the apparatus (e.g. liquid
filled objects, lighted candles).
q Where the MAINS plug or an appliance coupler is used as the
disconnect device, the disconnect device shall remain readily
operable.
r Use only power supplies listed in the user manual.
Safety-Important notes for users in the U.K. only
For users in the U.K.: please follow the instructions below
Mains plug
This apparatus is fitted with an approved 13 Amp plug. To change a fuse in
this type of plug proceed as follows:
a
Remove fuse cover and fuse.
b Fix new fuse which should be a BS1362 3 Amp, A.S.T.A. or BSI
approved type.
c Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it should be
cut off and an appropriate plug fitted in its place.
If the mains plug contains a fuse, this should have a value of 3 Amp. If
a plug without a fuse is used, the fuse at the distribution board should
not be greater than 3 Amp.
Note: The severed plug must be disposed off to avoid a possible
shock hazard should it be inserted into a 13 Amp socket elsewhere.
English
EN