Pioneer DEH-P6000UB - Manual (Page 28)

4 Turn MULTI-CONTROL to adjust the se-
lected segement.
Band
LOW (low)
—MID (mid)—HI (high)
Frequency
Low:
40HZ
—80HZ—100HZ—160HZ
Mid: 200HZ
—500HZ—1KHZ—2KHZ
High: 3KHZ
—8KHZ—10KHZ—12KHZ
Q factor
2N
—1N—1W—2W
# You can also perform the same operations by
pushing
MULTI-CONTROL up or down.
Adjusting loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Use MULTI-CONTROL to select
LOUDNESS.
2 Press MULTI-CONTROL to display the
setting mode.
3 Use MULTI-CONTROL to select the de-
sired setting.
Turn to change the setting.
LOW (low)
—MID (mid)—HIGH (high)—OFF
(off)
# You can also perform the same operations by
pushing
MULTI-CONTROL up or down.
Using subwoofer output
This unit is equipped with a subwoofer output
which can be turned on or off.
Also, phase can be selected between normal
and reverse.
1 Use MULTI-CONTROL to select
SW SETTING 1.
2 Press MULTI-CONTROL to display the
setting mode.
3 Use MULTI-CONTROL to select the de-
sired setting.
Turn to change the setting.
NORMAL (normal phase)
—REV (reverse
phase)
—OFF (subwoofer off)
# You can also perform the same operations by
pushing
MULTI-CONTROL up or down.
Adjusting subwoofer settings
When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
! When the subwoofer output is on, you can
select SW SETTING 2.
1 Use MULTI-CONTROL to select
SW SETTING 2.
# When the subwoofer output is on, you can se-
lect
SW SETTING 2.
2 Press MULTI-CONTROL to display the
setting mode.
3 Press MULTI-CONTROL to select the seg-
ment you wish to set.
Press
MULTI-CONTROL repeatedly to switch
the segment in the following order:
Cut off frequency
—Level
4 Turn MULTI-CONTROL to adjust the se-
lected segement.
Cut off frequency
50HZ
—63HZ—80HZ—100HZ—125HZ
Level
+6 to
–24 is displayed as the level is increased
or decreased.
# You can also perform the same operations by
pushing
MULTI-CONTROL up or down.
Audio Adjustments
En
28
Section
03