Philips FW C798 - Manual (Page 22)

22
English
3139 115 21261
Manual Preset Programming
1 Press TUNER (FM•AM) repeatedly to select
the desired waveband : FM or AM.
2 Press PROG.
➜
PROG will start flashing.
➜ The next available preset number will be
displayed for selection.
3 Press and hold à or á until the frequency
indication starts to change, then release.
➜ The display will show "
SEARCH" until a radio
station with sufficient signal strength is found.
To store the radio station to another
preset number
● Press í or ë to select the desired preset
number.
4 Press PROG again to store the radio station.
➜
PROG will disappear from the display.
● Repeat steps 2–4 to store other preset radio
stations.
Tuning to a weak radio station
● Press à or á briefly and repeatedly until the
optimal reception is found.
To stop storing the manual preset
● Press Ç on the system.
Notes:
– If you attempt to store more than 40 preset
radio stations, "
PROGRAM FULL" will be
displayed.
– During programming, if no button is pressed
within 20 seconds, the system will exit the Program
mode automatically.
Tuning to Preset Radio Stations
● Once you’ve preset the radio stations, press í
or ë to select the desired preset number.
➜ The preset number, radio frequency, and
waveband will appear on the display.
Radio Reception
Erasing a Preset Radio Station
1 Press í or ë to select the preset radio station
to be erased.
2 Press and hold Çon the system until “ PRESET
DELETED” appears on the display.
➜ The radio frequency remain on the display.
➜ The preset numbers of all other preset radio
stations in the band with higher numbers are
also decreased by one.
● Repeat steps 1–2 to erase other preset radio
stations.
For Recording, please refer to “Tape
Operation/Recording”.
pg 001-032/C798/37-Eng 4/16/02, 6:40 PM 22