Panduit Cougar LS9 - Manual (Page 29)

SETTING UP THE COUGAR LS9
AND USING FILE MANAGER
29
Label Modes
To edit the label mode, press the LABEL key.
1. Use the up or down directional arrows to select the desired mode and then
press .
Available Modes include:
MODE DESCRIPTION APPLICATIONS
Component Vertically centers legend Electrical and network
components
Wiremarker Repeats legend until label is filled Wire and cable marking
Terminal Places legends at terminal locations Terminal blocks
Tape Rotates legends 90° clockwise Safety/facility ID, pipe
marking and general
purpose labeling
Strip Repeats legend until label is filled
and copies legend on two sides of
middle perforation Wire and cable marking
Flag Prints legend once at top of label
and then repeats the legend once at
the bottom of label Wire and cable marking
Vertical Prints legend vertically Safety/facility ID, pipe
marking, and general
purpose labeling
NOTE: Another mode for DIN terminal block labeling is accessible by
pressing the F5 key. DIN terminal block labeling is based on
European standards and is primarily used in European countries.
For detailed instructions on using the DIN mode, refer to the
Labeling Exercises section of this manual.