Panduit Cougar LS9 User Manual
Page 23
CREATING LINES
23
Lines
Using lines allows custom placement of vertical and horizontal lines on a label.
Lines are especially useful for creating patch panel, faceplate, or terminal block
labels. There are seven unique line settings available: Center Horizontal,
Center Vertical, Top, Bottom, Left, Right, and @ Pages. Each of these settings
may be turned on or off independently.
NOTE:
The top, bottom, left, and right sides of the label will rotate with
the legend when a label is rotated.
1. The
Center Horizontal setting places a line through the center of the label in
the horizontal direction.
2. The
Center Vertical setting places a line through the center of the label in
the vertical direction.
3. The
Top setting places a line at the top of the label.
4. The
Bottom setting places a line at the bottom of the label.
5. The
Left setting places a line at the far left side of the label.
A01
A02
A01 A02
A01
A01
A01