Pro-tec Automobile Alarm - Manual (Page 6)

■ WIRING
1. Route wiring through trailer so chaffing
and/or pinching will not occur.
2. Solder or crimp connectors are trouble
free if done properly.
3. Insulate all connections with shrink tube
or quality electrical tape.
4. Never twist and tape wires together
without soldering.
■ INSTALLATION
1. Installation of 12 volt full size automo-
tive battery, grounded to trailer and
kept charged is needed for proper
operation.
2. Use 20 gauge wire from door switches
to control unit. Use separate wire for
each door and connect to terminal
block marked for that door.
3. Connect 12 gauge wire from trailer
running lights circuit to terminal block.
NOTE: The control unit is able to handle
20 amp load.
4. Connect 12 gauge wire from positive side
of trailer brake circuit to terminal block.