Pro-tec Automobile Alarm - Manual (Page 12)

Troubleshooting
Shock sensor doesn’t trigger alarm
Has the NPC system been triggered? To check
this press reset to clear the NPC memory and
then retest the shock sensor.
LED indicator flashing sequence
This feature is used to tell you if and what trigger
point was triggered while you were away. It also
helps determine where to look if you are
experiencing false alarms.
1. Steady Flashing .................System armed
2. No Flashing........................System disarmed
3. One Flash ..........................Generator door
4. Two Flashes .......................Shock sensor
5. Three Flashes ....................Side or rear door
To reset LED indicator
Disarm alarm. Then press reset button on control
module. LED should shut off.