PNY P-DSA150-PCI-RF - Manual (Page 17)

Aug/07 MN2036400000 17
3. Restart the computer when prompted by Windows’ installation.
4. At the Windows Setup screen, press F6 to install the RAID driver.
5. When prompted, press S to specify the location of the driver.
6. Inset the floppy disk, then press Enter.
7. Select Silicon Image SiI 3x12 SATARaid Controller (64-bit
Extended) or Silicon Image SiI 3x12 SATARaid Controller
(Itanium), then press Enter.
8. Press Enter to finish driver installation, then follow the on-screen
instructions to complete the Windows installation.
Note: If the Security Alert warning pops up, click Yes. Our driver has
passed Microsoft compatibility testing, this message appears during
new installation.
For An Existing Installation
1. Setup the RAID Array prior to driver installation and boot up to
Windows.
2. At the Found New Hardware Wizard, select No, not this time,
then click Next.
3. Insert the driver CD, select Install the software automatically
(Recommended), and click Next.
4. Click Finish.