Polycom IPOWER 70 - Manual (Page 7)

Attaching the Camera to a Monitor
7
Attaching the
Camera to a
Monitor Note: If you are installing a second monitor for a iPower 900
system, be sure to install the iPower 70 camera on the
NTSC or PAL monitor and not on the VGA monitor. If
you are installing a second monitor for a Concorde•4500
or Venue•2000 system, be sure to install the iPower 70
camera on the main monitor and not on the graphics
monitor.
To attach the camera to the monitor:
1. Clean the top of the monitor using a dry cloth. This helps the
adhesive on the bottom of the Velcro ® to adhere securely.
2. Without removing the backing from the adhesive strips, position
the camera on the top center of the monitor with the front base of
the camera within 0.75 inch (2 centimeters) of the front of the
monitor
.
3. With a pencil, mark the top of the monitor to indicate exactly where
you will be attaching the camera.
4. Remove the camera from the monitor and peel off the adhesive
backing from the Velcro strips.
5. Align the camera with the marks you made and firmly press it onto
the top of the monitor.
a
<0.75
inch
a