Polycom IPOWER 70 - Manual (Page 6)

INSTALLING THE IPOWER 70 ROOM CAMERA
6
Important Note
About Moving the
Camera The iPower 70 camera is designed to be controlled (moved) from the
collaboration system wireless keypad, the keyboard, or the remote
control. Be sure that your system is turned on before you move the
camera.
You should not manually move the camera from side to side (pan)
or up and down (tilt).
If you manually move the iPower 70 camera head, you may
experience unexpected camera pointing behavior when you use
camera presets.
To correct this condition, use the wireless keypad or the remote
control to do the following:
1. Press and hold the near-end right arrow button until the camera
rotates as far right as it can.
2. Press and hold the near-end left arrow button until the camera
rotates as far left as it can.
3. Press and hold the near-end up arrow button until the camera
moves up as far as it can.
4. Press and hold the near-end down arrow button until the camera
moves down as far as it can.
If the condition persists,
Power the collaboration system off and then on again.