Planet Technology PCI Fast Ethernet Adapter ENW-9503 - Manual (Page 3)

3. Connect your adapter to the network.
Connect the adapter to the network using twisted-pair cabling with an RJ-45
connector.
4. Power on the PC.
After hardware installation has been completed, power on the computer.
5. Change your computer's BIOS setup to enable Bus Master mode and select an
IRQ setting.
The setup procedure and the terminology used when referring to Bus Master
mode and IRQ parameters may vary with your computer's BIOS. Some BIOS have
Bus Master mode enabled for all the motherboard's PCI expansion slots, while
others provide the option to turn this feature on or off. Refer to your computer's
installation manual for more information. Please see the following section on
Adapter configuration for related information.
6. Install the software driver.
For related topics see the section on Software Drivers later in this chapter.
Specifications
System Configuration
Transmission Technique: Base band
Topology: Star
Transmission Rate: 10 Mbps and 100 Mbps (Auto-negotiation)
Full-Duplex Operation: 10 Mbps and 100 Mbps
Media Type Supported: Cat. 3, 4 and 5 UTP for 10BASE-T
Cat. 5 UTP for 100BASE-TX
Hub-to-Workstation Distance: 100m
Cable Connections: One RJ-45 (socket) for 100BASE-TX and 10BASE-T
Standards Conformance: IEEE 802.3 10BASE-T, and
IEEE 802.3u 100BASE-TX
End-User Devices Supported: PCI local bus-compliant PCs
Data Bus Width: 32-bit
Bus Access: Bus Master
I/O Address: Automatically determined by configuration space
Interrupt: INT A on PCI slot pin assignment, which is mapped to the BIOS IRQ
setup