Philips DTR6610 - Manual (Page 17)

4.3 Wake up your receiver or Switch to
standby
• You watch TV or listen to radio, press the standby button
to switch your receiver to standby.
• Your receiver is in standby, to wake it up:
- Either press the P+, P-, RADIO or any digit button on
the remote control.
- Or press one digit button.
- Alternatively, press the PROG-/PROG+ or
TV/RADIO button on the front panel.
4.4 Select TV or Radio mode
Your receiver may work in two modes: TV or radio. To
switch between these two modes, press the RADIO key.
If you are watching one of the TV channels, pressing
RADIO tunes to the last tuned radio channel belonging
to the previously selected channel list. Pressing RADIO
again returns to the TV mode -to the last tuned TV
channel. Alternatively, use the TV/RADIO front panel
button.
On switching the mode, the Channel Banner appears
for its timeout. In the radio mode, the radio label
appears/disappears at random positions on the screen to
avoid damaging your TV screen.
Radio Label
4.5 How to switch between channels in
the list
Your receiver gives you access to TV Channel List and to
Radio Channel List.
To display the currently selected channel list, press the
FAV key. To change the channel list press C or B keys.
Then select the channel by pressing V or W, or number
keys. Each time you highlight a non-current channel, the
icon appears in the Channel Banner. To tune to
this channel, press OK.
TV Channel List
Note: Channels lists allow you to work in so-called browsing
mode. In this mode, the box remains tuned to the same
channel, while you browse through channels and programs.
English
DAY T O DAY O P E R AT I O N 15
6610_A5_GB.qxd 01/09/2004 12:58 Page 15