Installing on a light pole or electrical pole, Installing on a light pole or, Electrical pole – Polycom SPECTRALINK 6000 User Manual

Page 10

1725-36127-001-F.doc

Installing on a Light Pole or

Electrical Pole

Items provided:

Outdoor enclosure, Base Station

Items needed:

4 - “Caddy” or “B-Line” 3/8” beam clamps

2 - EOG 100 or equivalent band clamps

1. Attach one band to the top flange of the outdoor enclosure

using two beam clamps (see the figure below).

2. Attach the second band to the bottom flange of the enclosure

using the remaining two beam clamps.

3. Wrap the band clamps around the pole and tighten using the

screw on the band clamps.

See figures in Chapter 1 for pictorial data for the remaining steps:
4. Slide the Base Station cable through the compression fitting

and tighten the fitting.

5. Crimp an RJ45 onto the Base Station cable using the same

wiring guide as the indoor Base Station.

6. Plug the RJ45 into the RJ48C connector.