Philips SBCHD1500U - Manual (Page 26)

RED blinking (2 secs) + short GREEN burst + all other indicators on the
headphone are off - Power save mode
The power save mode is initiated when there is no valid radio signal
available or after digital silence for 1 minute. In the ‘power save mode’, the
headphone is in fact still operational but not continuously. It will restart
every 2 seconds to look if in the meantime it can receive a valid radio
signal. During the power save mode, the system status LED will turn green
when the headphone starts searching for a valid radio signal and will be off
for the rest of the power save mode. As soon as a useful radio signal is
detected, the other functions, peripherals and indicators are re-enabled
again. Only from that moment onwards, the system status indicator will
return to green.
Series of (5 x 200ms) beeps – Out of range
• Move closer to the base station
* TREBLE
Treble enhancement (on/off) for high tones boost. When activated, the
indicator will be illuminated in yellow.
( VOLUME
Volume up/down tumble push-button
) BASS
Dynamic Bass Enhancement (on/off) for deep bass boost. When activated,
the indicator will be illuminated in yellow
Remote Control
¡ STANDBY-ON
• Red = base station in standby mode
• Green = base station in active mode
™ MOVIE
Press to select the MOVIE mode of Dolby Pro Logic II
£ ROOM1
Press to select ROOM 1 mode (small room) of Dolby Headphone.
≤ ROOM2
Press to select ROOM 2 mode (large room) of Dolby Headphone.
ENGLISH 26