Peavey Century Series User Manual
Page 34
V
X
A
PPENDIX
A
C
ENTURY
S
ERIES
VX User Options
VX consoles are shipped having standard configuration unless specified at time of order. These are ways that the console config-
uration may be varied after manufacture. The items listed are internal options selected by gold jumper links or pcb DIP switches.
DIP switch 'ON' position is down when reading the numbers on the switch body.
Jumper link default is marked with a line on the board and is usually pins 1&2 of the three pin header.
In addition there are links for module function assignment. Take care to not disturb these when using USER OPTION links.
MODULE
LOCATION
OPTION TITLE
FUNCTION
M=Main board
C=Connector
Shipped with option underlined
Inputs
M
J2, Pre Feed 1: Mute ?
Aux sends with Mute or without Mute
M
J3, Pre Feed 1: Source
Aux sends Pre or Post EQ
M
DIP switch 1-7
Aux 1-7 override Global Pre (local Pre)
M
DIP switch 8
Aux 8 Direct Out = Pre Feed 1 or 2
M
J4, Pre Feed 2 (never mute)
Aux 8 Direct source, Pre EQ or Pre-fader
M
J5, Input Meter Source
Preamp, Pre-fader, Post-fader
VX Stereo In
C
behind GAIN pot
Phase invert: L only or L+R
M
J4: Aux Pre Source
with MUTE or without MUTE
M
J2: Left Pre Source
Pre EQ or Pre Fader
M
J3: Right Pre Source
Pre EQ or Pre Fader
VX Multi Input
same as Stereo Input
VX Groups
M
SEL 4: VCA Mute Atten
VCA mute affects Ch Mute; VCA mute affects Ch VCA
C
Insert: selector switch
Group insert or Matrix insert
VX L & R
C
Connector board SEL 4
feed to ALT (Mono module) Pre or Post insert
M
SEL 3 Aux local Mute
Link on = Enable, or Link off = Master Mute only
VX Mono
M
SEL1,3,5,7,9,11,13,15
Stereo Prog In: Aux Stereo or Mono
M
SEL2,4,6,8,10,12,14,16
Stereo Prog In: Aux Send On or Off
VX Master
C
SEL1 TB Phantom Power
On or Off
C
SEL2 TB Gain select
20, 30, 40dB gain
IMPORTANT
Group Modules and Left/Right Modules are pre-assigned at the Crest factory
These modules must always be installed in the correct positions. They are NOT interchangeable without being properly re-
assigned. Please contact the Crest Audio Service Department for more information.