Polaris Hawkeye 9920787 - Manual (Page 46)

43
FEATURES AND CONTROLS
All Wheel Drive (AWD) System (4X4 Models)
The All Wheel Drive system is
controlled by the AWD switch.
When the switch is on 2X4, the
ATV is in two-wheel drive at all
times. When the switch is on
AWD, the ATV is in all wheel
drive and the AWD indicator light
in the instrument cluster will be
on.
When in AWD, the demand drive unit will automatically engage any
time the rear wheels lose traction. When the rear wheels regain traction,
the demand drive unit will automatically disengage.
NOTE: The override switch allows activation of AWD in reverse if the AWD
switch is on. See page 34.
There is no limit to the length of time the vehicle may remain in AWD.
Engaging AWD
The AWD switch may be turned on or off while the vehicle is moving.
Initially, the vehicle's electronic system will not enable the AWD until
the engine RPM is below 3100. Once enabled, the AWD remains
enabled until the AWD switch is turned off. If the switch is turned off
while the demand drive unit is moving, it will not disengage until the
rear wheels regain traction.
Engage the AWD switch before getting into conditions where front
wheel drive may be needed. If the rear wheels are spinning, release the
throttle before switching to AWD.
CAUTION
Switching to AWD while the rear wheels are spinning may cause severe drive
shaft and gearcase damage. Always switch to AWD while the rear wheels
have traction or are at rest.
AWD
Switch