Pioneer DJM-700-S - Manual (Page 21)

MIDI SETTINGS
21
En
MIDI SETTINGS
MIDI is an acronym for “Musical Instrument Digital Interface” and
refers to a protocol developed for the exchange of data between
electronic instruments and computers.
A MIDI cable is used to connect components equipped with MIDI
connectors to enable the transmission and receipt of data.
The DJM-700-S/DJM-700-K uses the MIDI protocol for transmitting
data about component operation and BPM (timing clock).
SYNCHRONIZING AUDIO SIGNALS TO
EXTERNAL SEQUENCER, OR USING
DJM-700-S/DJM-700-K INFORMATION TO
OPERATE AN EXTERNAL SEQUENCER
1 Use a commercially available MIDI cable to connect the
DJM-700-S/DJM-700-K’s MIDI OUT connector to the MIDI
sequencer’s MIDI IN connector.
• Set the MIDI sequencer’s synch mode to “Slave”.
• MIDI sequencers that do not support MIDI timing clock
cannot be synchronized.
• Synch may not be achieved if the track’s BPM cannot be
detected and measured stably.
• BPM values set with the TAP mode can also be used to
output the timing clock.
2 Press the MIDI START/STOP button.
• The MIDI timing clock output range is 40 to 250 BPM.
[MIDI Channel Setting]
The MIDI channel (1 to 16) can be set and stored in memory.
1 While holding the MIDI START/STOP button depressed, set
the power switch to ON.
• The display will show [ CH SET ] and the unit will enter the
MIDI setting mode.
2 Rotate the TIME dial to select the MIDI channel.
3 Press the MIDI START/STOP button.
• Records MIDI channel. During recording of channel, [ SAVE ]
indicator flashes.
• When recording of channel is completed, [ END ] is
displayed.
4 Set power to OFF.
DJ CD Player
MIDI sequencer
Audio
MIDI START
/STOP
TIME
MIDI OUT
DJM-700-S/DJM-700-K
OUT
BPM
=120
BPM
=120
IN
IN
01_DJM-700_En.book 21 ページ ２００７年７月１０日 火曜日 午後８時５１分