Polk Audio SURROUNDBAR 400 - Manual (Page 5)

MOUNTING THE SURROUNDBAR 500 CHT
SDA CONTROL MODULE
The SurroundBar 500 CHT SDA Control Module can be mounted
on a wall, either vertically or horizontally, into a rack using the
supplied rack mount ears, or it may be placed on a flat surface.
The location of your other electronic components will determine
which location will work best for you.
WALL MOUNTING THE SDA CONTROL MODULE
Overall Dimensions
1. 8" H (20.32cm)
2. 17" W (43.18cm)
Keyhole Slots
3. 14 3/4" W (37.47cm)
1. Determine if you want to mount the SDA Control Module
vertically or horizontally. Then hold it in your intended
location to be sure there are no obstructions to the
SurroundBar and to your receiver, and to determine
the length of the speaker wires you will run for each
channel from your receiver to the SDA Control Module.
2. Using the SDA Control Module Wall Mount Template,
mark and drill the holes for the mounting screws
or wall anchors as appropriate. Use a molly bolt
or wall anchor if a second stud is not available.
3. The SurroundBar cable plugs into the SDA Control Module
and the SurroundBar. Run speaker wire (not included) from
your receiver to the SDA Control Module. Make the appro-
priate connections based on whether you are using the
500 CHT in 7CH, 5CH or LCR mode (see pages 8 - 10).
4. With the SDA Control Module wired and the SurroundBar
cable plugged in, set the 7CH, 5CH or LCR switch to the
appropriate setting and hang the module on the wall.
5. Tug gently on the module while holding it from below
to ensure it has seated properly on its keyhole slots.
Customer Service Hours of Operation: Monday-Friday, 9 AM -5:30 PM EST [email protected] 5
3
1
2
Wall mounted vertically or horizontally.
Rack mounted using supplied rack mount ears.
Placed on a flat surface.