Philips CDR 786 - Manual (Page 3)

3
English ....................................................4
Français.................................................34
Español .................................................66
Deutsch.................................................97
Nederlands .........................................129
Italiano................................................159
Svenska...............................................190
Dansk ..................................................220
Suomi..................................................250
Português............................................280
ŒÏÏËÓÈο .........................................310
English
Français
Español
Deutsch
Nederlands
Italiano
Svenska
Dansk
Suomi
Português
∂ППЛУИО¿
Polski...................................................342
Polski
Important notes for users in the U.K.
Mains plug
This apparatus is fitted with an approved moulded 13 Amp
plug. To change a fuse in this type of plug proceed as
follows:
• Remove fuse cover and fuse.
• Fix new fuse which should be a BS1362 5 Amp, A.S.T.A. or
BSI approved type.
• Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it
should be cut off and an appropriate plug fitted in its place.
If the mains plug contains a fuse, this should have a value of
5 Amp. If a plug without a fuse is used, the fuse at the
distribution board should not be greater than 5 Amp.
Note: The severed plug must be disposed to avoid a
possible shock hazard should it be inserted into a 13 Amp
socket elsewhere.
How to connect a plug
The wires in the mains lead are coloured with the following
code: blue = neutral (N), brown = live (L).
As these colours may not correspond with the colour
markings identifying the terminals in your plug, proceed as
follows:
• Connect the blue wire to the terminal marked N or
coloured black.
• Connect the brown wire to the terminal marked L or
coloured red.
• Do not connect either wire to the earth terminal in the
plug, marked E (or e) or coloured green (or green and
yellow).
Before replacing the plug cover, make certain that the cord
grip is clamped over the sheath of the lead - not simply over
the two wires.Copyright in the U.K.: Recording and playback
of material may require consent. See Copyright Act 1956 and
The Performer’s Protection Acts 1958 to 1972.
xp CDR785/00 engels.4 14-11-2000 16:30 Pagina 3