Philips FlexCare HX6942 - Manual (Page 9)

Quadpacer
The Quadpacer is an interval timer that has a short beep and pause to
remind you to brush the 4 sections of your mouth. Depending on the
brushing mode or brushing routine you have selected, the Quadpacer
beeps at different intervals during the brushing cycle. See the ‘Brushing
instructions’ and ‘Personalising your brushing experience’ sections.
The Quadpacer on this model has been activated. To deactivate or
reactivate the Quadpacer:
1 Place the handle with a brush head attached on the plugged-in
charger or sanitiser
To deactivate the Quadpacer: press and hold the Personalised
Brushing button for seconds. You hear 1 beep to indicate that the
Quadpacer has been deactivated.
To reactivate the Quadpacer: press and hold the Personalised
Brushing button for seconds until you hear beeps. This indicates
that the Quadpacer is active again.
Note: The Quadpacer cannot be deactivated on the pre-programmed Go Care
and Max Care brushing routines.
Cord wrap on deluxe charger (specific types only)
If your model includes the deluxe charger cover and base, the travel
charger is pre-installed inside the cover. If you want to shorten the mains
cord, you can store excess cord in the cord-wrap feature built into the
charger base.
1 To separate the charger cover from the charger base, press the two
grey snap bars on the charger base and pull the white charger cover
upwards.
Wrap excess cord around the grey charger base as shown in the
picture. Be sure to wrap the cord on the inside of the two snap
levers.
3 When you have stored the excess cord, guide the cord through the
small groove in the rear of the grey charger base.
4 Reattach the charger cover by pressing it down over the charger
base until it snaps into place.
Tip: For extra convenience during travel, you can remove the travel charger and
use it without the charger cover and charger base.
-
,
1
2
4
3
1
2
4
3
EnglisH