Philips SDV2750/27 - Manual (Page 5)

5
ENGLISH
4 Using your indoor
television antenna
4.1 Adjusting Low-High amplifier level
1
Turn the amplifier “ON/OFF” switch on
the antenna to the “ON” position.
4
2
Set the Low-High amplifier level switch
according to your location.
5
For locations that are relatively close to local
TV transmitters (less than 10-15 miles) set the
switch to the ”L” position.
For locations that are further away from local TV
broadcast transmitters (more than 15 miles) set
the switch to the “H” position.
4.1 For VHF/FM reception
1
Extend the telescoping dipoles to the
longest possible length.
6
2
Turn your TV or FM radio to the desired
channel/station. Adjust the dipoles by moving
in different directions up and down, until
reception is achieved.
7
3
Turn on the amplifier by rotating the VHF
gain control knob towards the max position
until reception is improved.
8
D Note
If you are unsure of the distance from the local
TV broadcast transmitters to your location, visit
www.antennaweb.org where you can enter your
address and obtain local map that will provide
this information.
D Note
Depending on your location and surroundings,
you may obtain the best possible reception with
the amplifiers turned to the minimum level.
6
7
8
4
5
2750_27.indb 5 5/7/08 10:32:46 AM