Pioneer CDJ-1000MK2 - Manual (Page 8)

8
En
C Connecting to a component with a digital input terminal
CD recorder or amplifier
with digital inputs
Digital signal cable
CDJ-1000MK2
3. Connecting to other devices
A Connecting to other mixers
Connect the AUDIO OUT terminal on the unit with the Line In terminal or AUX terminal on the mixer.
(Do not use the Phono terminal. Otherwise the sound will become distorted and prevent normal playback.)
B Connecting to a stereo amplifier (when not using a DJ mixer)
Stereo amplifier
Connect to the AUX input terminal.
(Do not use the Phono input terminal.)
Supplied audio cable
CDJ-1000MK2
BEFORE OPERATIONS: CONNECTIONS
7 Setting the DIGITAL OUT Mode Switch (rear panel)
When the unit is used normally as a DJ CD Player, this switch should be set to DJ.
When set to DJ:
÷ The DIGITAL OUT connector outputs only audio data without sub-codes. The mode, however, is fixed at 44.1 kHz.
Recording and other functions may be limited, depending on the type of CD recorder or other component connected. For details, consult the operating instructions for the
component concerned.
÷ When DIGITAL OUT mode switch is first set to DJ, the display initially shows “D-OUT” then changes to “DJ.”
When set to NORMAL:
÷ The DIGITAL OUT connector outputs digital data including sub-codes, but the unit’s DJ functions are seriously restricted. ☞ P. 9
÷ When the DIGITAL OUT mode switch is set to NORMAL, the display initially shows “D-OUT” then changes to “NORMAL.”
÷ If an unsupported operation is attempted, the display will first show “D-OUT” then change to display the “NORMAL” message.
÷ If the DIGITAL OUT mode switch has been set to NORMAL when the unit’s power is switched on, the display will initially show “D-OUT,” then change to display the
“NORMAL” message.
NOTE:
When the DIGITAL OUT mode switch is set to NORMAL, the DJ functions (cue, loop, reloop, tempo adjust, hot cue, Jog dial and reverse playback) do not work. And the
muted pause mode is used instead of the audible pause mode.
4. Connecting the power cord
When all connections have been made, connect the power cord to the AC inlet on the rear panel of the player and connect the power plug to an AC wall outlet or to a power
receptacle on the rear panel of the amplifier.