Philips CCZ092AT - Manual (Page 6)

6 Hooking Up the TV/VCR
ANT.
Hooking Up Your TV/VCR With a
Cable Signal or Outdoor Antenna
IN OUT
ANT.
Connect an RF coaxial cable (75-
ohm, not supplied) to the OUT
Jack on the Cable Box and to the
ANT(enna) Jack on the TV/VCR.
Connect a Cable signal or an anten-
na to the ANT(enna) Jack.
Hooking Up Your TV/VCR With a
Cable Box
To view any channel, set the TV/VCR to the
Cable Box output channel (channel 03 or 04).
Then, select channels at the Cable Box.
1
Hook up your TV/VCR using one of the connections shown.
A.
B.
ANT.
Rod Antenna
Hooking Up Your TV/VCR With an
Indoor Antenna
To install a rod antenna (supplied), push the
stem of the antenna into the antenna hole on
the top of the TV/VCR. Connect the antenna
wire to the ANT(enna) Jack on the back of
the TV/VCR as shown. Extend the antenna
and adjust its length, direction, and angle for
the clearest picture.
C.
Connect the Cable signal to the IN
Jack on the Cable Box.
CCZ092comb.QX33 4/5/99 6:05 PM Page 6