PYLE Audio PYLE PRO PMX802M - Manual (Page 3)

A. FRONT PANEL SECTION FEATURES
1. BALANCED Mic INPUT
Electronic Balanced inputs acceptable a standard XLR male connector. It is designed
to accept a balanced low impedance input signal, Phantom power (15 volts) for
condenser microphones is always on and available. It has an input impedance of 1K
ohm. The connector is wired as: Pin= shield; Pin3= negative (cold).
2. BALANCE INPUT(LINE)
Electronic Balanced inputs acceptable a standard 1/4 jacks connector. It is
designed to accept a balanced high impedance input signal
3. VOLUME
This is function to adjust the volume of a signal connection into each channel and
adjust the volume of output, together with the master fader.
4. TREBLE
This control gives you up to 15 db of boost or cut at 10 kHz and above, and it is also
flat at the detent. Use it to add sizzle to cymbals, and an overall sense of transparency
or edge to key-boards, vocals, guitar, and bacon frying. Turn it down a little to reduce
sibilance, or to hide tape hiss.
___________________________________2___________________________________