Lenoxx Electronics CD-160 - Manual (Page 8)

CLOCK SETTING CLOCK SETTING CLOCK SETTING CLOCK SETTING CLOCK SETTING
Connect the AC power cord or install 8 size “D” batteries, the LCD display will show:
The clock is adjusted with the Power Switch off. To set the time, do as follows:
1. Press the Clock Set Button, the hour digits will flash for 10 seconds.
2. Press the Time or Button to select the correct hour time. Observe the
AM & PM indicators, advance the time 12 hours to change AM to PM.
3. Press the Clock Set (Program) Button to accept the hour time and switch to minute
setting.
4. Press the Time or Button to select the correct minute time.
5. Press the Clock Set (Program) Button again to complete clock setting.
6. The numbers will not flash, but the colon “ : ” will flash, indicating that the clock is set.
NOTE: If the Power Switch is ON and you want to set the time, press the Tape Switch
first, and then follow the above steps to set the clock.
H O U R H O U R H O U R H O U R H O U R MINUTE MINUTE MINUTE MINUTE MINUTE
BASS BOOST SWITCH BASS BOOST SWITCH BASS BOOST SWITCH BASS BOOST SWITCH BASS BOOST SWITCH
This set has a Bass Boost Switch which allows you to hear more bass (low frequency)
sounds. You may slide it ON or OFF to your taste (Bass means low frequency sounds
like a bass drum).
STEREO HEADPHONE JACK STEREO HEADPHONE JACK STEREO HEADPHONE JACK STEREO HEADPHONE JACK STEREO HEADPHONE JACK
A Stereo Headphone Jack has been provided on the front of the set so that you can
listen to the set without disturbing others. To use this jack, plug in low impedance
stereo headphones (4 Ohm, not included) and adjust the Volume Control to your taste.
Special internal switches will turn off the set’s speakers when you plug in the stereo
headphones.
BASS BOOST
OFF ON
7
CD-160S050699 V.2 E
NOTE NOTE NOTE NOTE NOTE
The control panel has different color lettering to help you identify the multi-
Button functions:
BLACK COLOR = CD BUTTONS
RED COLOR = CLOCK SETTING BUTTONS
BLUE COLOR = RADIO & PRESET BUTTONS