Cd opera, Cd opera cd operation tion tion tion tion, Handling a disc – Lenoxx Electronics CD-160 User Manual

Page 10

5. The Display will show 6 zeros and then

the total number of tracks (songs) and the total play

time of the disc. (If the disc is upside down

upside down

upside down or

CD OPERA

CD OPERATION

TION

Since any dirt, scratches or warping of the disc can cause

skipping or intermittent sound or noise, bear in mind the

following points:

When holding the discs, take care not to touch the playing

surface.

Store the discs in their cases. Return them to their cases

with the label surface facing up and push down lightly on

the label surface.

Do not place discs near a heating device or a place where

the temperature is high or in dusty areas.

Do not write on the label surface using a ballpoint pen and

do no stick labels on the CD.

Wipe away any fingerprints or dust on the playing surface

of a disc using a soft cloth.

Bear in mind the following points when cleaning your discs:

- Always wipe from the inside toward the outside of the disc.

- Never in a circular motion.

- Do not use conventional record cleaners, anti-static agents,

benzene, thinner or other solvents.

PLA

PLAYING A

YING A

YING A CD (COMP

CD (COMP

CD (COMPACT

ACT

ACT DISC)

DISC)

1. Press the Power Switch ON, the Power/Batt. Lamp will light.

2. Press the CD Switch, the CD Indicator Lamp will light.

3. Press the CD Door Open Button (near the door) to open the CD door.

4. Insert a CD with the LABEL

LABEL

LABEL side facing UP

UP,

, ,

, close the CD Door gently by pushing

it down.

HANDLE DISC AS SHOWN

CLEAN FROM CENTER TO EDGE

HANDLING A DISC

Although built to withstand a certain amount of the effects from dust, soil and scratches,

discs should be treated with care normally accorded to conventional analog discs

(records). Always protect a disc against scratches, soil and dust etc. We recommend

that during non-use periods, the discs should be stored in their original cases.

TRACK

6. To start the music, press the CD Play/Pause Button (wait a few seconds for music

to start). The first track number will appear in the Display, and the disc will

start playing. The played time shows in the Display also.

7. Adjust the Volume Control to your taste. For extra bass sound, slide the Bass

Boost Switch ON.

damaged

damaged, the Display will show 6 zeros , and then

will be

flashing).

8. To pause the music - if the phone rings or other reasons,

press the CD Play/Pause Button, the elapsed play time

will flash to remind you that you are in pause mode.

9. To resume the music from pause, press the CD Play/Pause Button again. The

track number will be steady on (not flashing

not flashing

not flashing).

10.To stop playing music, press the CD Stop Button.

11. To shut the power off, press the Power Switch again, and the Power/Batt. Lamp will

go off.

TRACK

CD-160S050699 V.2 E

INTRO PROGRAM

This set is designed to play only compact discs bearing this identification logo (logo

must say DIGITAL AUDIO).