Linksys EFG120 - Manual (Page 50)

43 Appendix C: Setting Up the Built-in PrintServer
EtherFast Network Attached Storage (120GB with PrintServer)
Appendix C: Setting Up the Built-in PrintServer
When you are ready to use the Network Attached Storage’s built-in PrintServer, follow these instructions:
1. Power down the Network Attached Storage by pressing the power button on the front panel.
2. Connect your printer’s parallel cable to the PRINTER port on the back panel of the Network Attached Storage.
3. Power on the Network Attached Storage.
4. On your Windows desktop, click the Start button.
5. Select Settings, and then click Control Panel.
6. Double-click the Printers folder.
NOTE: As screens vary between operating systems, you may find that the screenshots in this
appendix look a little different from your own operating system. The instructions, however, are
still applicable.
Figure C-1: Click Start Button
Figure C-2: Double-Click Printers Folder