Lindy PRO-300 - Manual (Page 14)

English Manual
LINDY KVM Extender C5 PRO-300 Installation and Use page 14
3.6 Audio connections
Audio connections are available at the two 3.5” jack sockets mounted
on the side (same side as the switch bank) of the REMOTE module.
Note: The microphone input has a dual function whereby it can either support a mono-channel microphone or
alternatively receive stereo line input. Switch 3 on the LOCAL module controls the setting of this port: LOCAL
switch 3 OFF - microphone, LOCAL switch 3 ON - stereo line in.
1
Connect the microphone (or stereo line input) plug into the REMOTE module microphone socket.
(Note: Ensure that the setting of switch 3 on the LOCAL module matches the input to this socket:
OFF - microphone; ON – stereo line input)
2 Connect the speaker plug to the REMOTE module speaker socket.
Note: When the REMOTE module is rack mounted, the audio connections must be made
after the module has been fixed in place. Access is required to the rear and above the rack.
Remember to remove the audio connections before attempting to slide out the REMOTE
module.