Liebert Air Cooled User Manual
Liebert, Air cooled, direct drive condensers
This manual is related to the following products:
Table of contents
Document Outline
- 1.0 Introduction
- 2.0 Site Preparation
- 2.1 Site Considerations
- 2.2 Dimensions and Weights
- Table 1 Condenser shipping weights, dimensions and volume, approximate
- Figure 3 Condenser planning dimensional data-One-fan and two-fan units
- Figure 4 Condenser planning dimensional data-Three-fan and four-fan units
- Figure 5 Condenser planning dimensional data-Six- and eight-fan units
- Figure 6 Typical condenser footprint-dimensions
- Figure 7 Piping connection locations for 1-, 2-, 3- and 4-fan VFD Control and Fan Speed Condensers
- Figure 8 Piping connections for 1-, 2-, 3- and 4-fan Lee-Temp and Quiet-Line Condensers
- Figure 9 Piping connections for 6- and 8-fan Fan Speed Condensers
- Figure 10 Piping connections for 6- and 8-fan Lee-Temp and Quiet-Line Condensers
- Table 2 Condenser physical data
- 2.3 Refrigerant Planning Values
- 3.0 Inspection and Installation
- SAFETY INFORMATION
- Figure 11 Equipment recommended for handling a Liebert condenser
- 3.2 Handling Unit on the Skid
- 3.3 Unpacking the Unit
- 3.4 Preparing a 1-, 2-, 3- or 4-Fan Condenser for Moving and Installation
- 3.5 Preparing a 6-Fan or 8-Fan Condenser for Moving and Installation
- 3.6 Electrical Supply Preparation
- 3.7 Electrical Connections
- 3.8 Electrical Field Connection Descriptions
- 3.9 Refrigeration Piping Connections
- 3.10 System Dehydration/Leak Test and Charging Procedures
- 4.0 Checklist for Completed Installation
- 5.0 Operation
- 6.0 System Maintenance