Linn CLASSIK Movie Di - Manual (Page 53)

47
English
U
ser Options
User Options
This chapter explains how you can configure certain functions of the CLASSIK Movie Di
to suit your own requirements.
Changing the user options’ settings
To change the user options’ settings:
using the front panel -
● Put unit into standby mode.
● Hold until the display shows USER OPTIONS.
● Repeatedly press or hold or to select the required user option.
● Repeatedly press or hold or to change the setting of the user option.
To restore a user option to its default value:
using the front panel -
● Select the required user option.
● Press ‘enter’.
To exit user options mode:
using the front panel -
● Press .
The user settings are saved and the unit turns on.
Table of user options
The following table shows the user options that are available, briefly describes them and shows the available settings for each. Default settings are shown in bold.
Option/Name Description Settings
Set display brightness Allows adjustment to brightness of front panel display. When set to AUTO the unit will select a brightness level Auto
based on the ambient light level in the room (the greater the ambient light level, the brighter the display will be). 6% - 100%
Enable source memory On: Each source has its own volume, bass, treble, balance and fader settings. On
Off: All the sources use the same volume, bass, treble, balance and fader settings. Off
Enable IR sensor Enables/disables control of the unit from the handset. On
Off
Set IR modulation: IR out 1 Modulation frequency for infrared flasher 1. If default is not used then the frequency is in the range 36 kHz
1 to 576 kHz (non-linear). 1 to 576 kHz
Set IR modulation: IR out 2 Modulation frequency for infrared flasher 2. If default is not used then the frequency is in the range 56 kHz
10 to 2304 kHz (non-linear). 10 to 2304 kHz
Configure ACC socket Defines the use of the accessory socket (ACC). IR = infrared repeater IR
RCU = KNEKT remote control unit RCU
Configure Knekt mode Auto: Determines whether the unit is being used in a CONNECT or KNEKT system. Auto
Main: See KNEKT documentation. Main
Room: See KNEKT documentation. Room
Enable auto-selection: CD If an external CD player is connected to the CLASSIK Movie Di and you want the CLASSIK Movie Di On
to ignore CD handset commands when it is not in DISC mode, set to Off. Off
Enable auto-selection: Tuner If an external tuner is connected to the CLASSIK Movie Di and you want the CLASSIK Movie Di to On
ignore tuner handset commands when it is not in TUNER mode, set to Off. Off