LG 32LD333H - Manual (Page 264)

52 206-4186
Warning: Do not connect
a clone programmer to a
PPV card installed in the
Master or Target TVs. Also, if
the TV is in LodgeNet PPV Mode
(check with the site administrator
if you are not certain), do not
connect a clone programmer to
the GAME CONTROL/MPI port.
Either of these actions will
damage the clone programmer
and, if applicable, the PPV card.
• After cloning operations are complete, unplug the TLL-1100A/LT2002 from the TV.
• If the TV does not display a picture (blank screen) after a few seconds, just change channels.
Troubleshooting (Cont.)
Clone Programmer Troubleshooting
Symptom Possible Cause(s) Possible Solution(s)
Clone Programmer
Clone copies setup in less
than 30 seconds.
Not enough time to copy entire
TV setup.
TLL-1100A: Turn the TLL-1100A OFF and then ON.
LT2002: Press RESET on clone programmer.
Then redo Learn/Teach. (Learning usually takes about 90 seconds;
Teaching usually takes 3 to 4 minutes.)
Remote does not operate
clone programmer.
Wrong Installer Remote. Only use an LG Installer Remote to operate clone programmer
with TV.
Clone menu does not
appear on display panel
screen, TLL-1100A shows
error message, or LT2002
LED does not blink.
MPI cord not connected. Connect MPI cord properly, and ensure good connection.
TV not turned ON. TV must be powered ON for clone programmer to work.
(LT2002 only) Weak batteries. Install four (4) fresh AA high-quality alkaline batteries.
(TLL-1100A only) No charge. Ensure the TLL-1100A is fully charged or connected to AC power.
Clone menu hard to read. Weak signal. Connect TV to a reliable analog channel signal source.
No time set. Time not available. Set time on a TV, and copy time to clone programmer.
Clone not working. Clone programmer problem. • Try a different clone programmer.
• Reset the clone programmer.
Clone scans channels
more than once.
Clone should only scan channels
once.
Ensure TV is set up correctly, and try cloning again.
Master and Target TVs
Cloning did not work. Procedure interrupted. Wait until procedure complete message is displayed.
Different TV models. Cloning is only possible with identical model TVs.
Step(s) omitted or not performed. Refer to the applicable cloning procedure(s), and make sure all
tasks were performed.
(LT2002 only) Clone time
disappeared.
Batteries were removed. Batteries must remain installed to retain time settings.
New setup not present. Target TV not reset. Disconnect Target TV from AC power for 15 seconds.
Reset Clone Programmer After Static Shock
After replacing exhausted batteries (LT2002 only), or if the clone programmer
behaves strangely after a static shock:
• TLL-1100A: Turn the TLL-1100A OFF and then ON.
• LT2002: Use a paper clip or similar instrument inserted through the small hole
marked RESET to activate the internal reset switch and restore normal operation.
After a reset, check the real-time clock setting. It may be necessary to set the
clone programmer clock from a TV containing the correct time.
Note: Both the Master and Target TVs must be in Pass-through Mode for cloning
purposes. See also IMPORTANT CLONING INFORMATION on page 23.