Lanier 5227 User Manual
Page 71
Remote Maintenance by Telnet (mshell)
Additional Functions
6 - 11
Network Boot
Use the set command to configure a network boot.
msh> set parameter {on | off}
“On” means active and “Off” means inactive.
•
When you use RARP+TFTP, BOOTP, DHCP, the server also needs to be configured.
•
DHCP takes precedence over all other settings.
on | off}
Protocol
Use the set command to allow/prevent remote access for each protocol.
msh> set protocol {up | down}
Notes:
•
If you prohibit remote access using TCP/IP and then logout, you cannot use remote
access. If this was a mistake, you can use the printer operation panel to allow access by
TCP/IP.
•
When you prevent access via TCP/IP, you are also prevented from using lpr, ftp, rsh,
diprint, and web.
Parameter
Configuration Method
ping
ARP+PING
tftp
RARP+TFTP
bootp
BOOTP
dhcp
DHCP
Protocol
Description
appletalk
UP means active and Down
means inactive.
tcpip
netware
netbeui
lpr
ftp
rsh
diprint
web