Liebherr HC1001 - Manual (Page 3)

u Examine the unit and packaging for shipping damage.
Contact the carrier immediately if you suspect there is
any damage.
u Note the type (model, number), index, appliance/serial
number, date of purchase and where purchased on the
spaces provided in see Appliance Information.
u Remove anything attached to the rear or side walls of
appliance that would prevent proper installation or im-
pede proper ventilation.
If the appliance is set up in humid areas, condensation may
build on the outside of the appliance.
u Always ensure proper ventilation.
3 Changing the door hinges
Make sure you have the following tools on hand:
q
Hex wrench 13
q Cordless screwdriver Torx 15, 20, 25, 30
Push the appliance 2/3 of the way into the recess.
Disconnect the power plug.
Open the doors.
3.1 To detach the soft stop mecha-
nism*
CAUTION
Risk of injury if soft stop contracts!
u Detach with care.
Fig. 1
u Unscrew retainer Fig. 1 (1) .
u Unscrew ball stud Fig. 1 (3) together with the soft stop
mechanism Fig. 1 (2) from the door and set to one side.
3.2 Reversing the door
Fig. 2
u Lift off covers Fig. 2 (5,6,7,8) using a slot screwdriver.
u Just loosen top and bottom screws Fig. 2 (9) on the body
of the appliance.
u Push doors outwards and unhook.
u Swap screws Fig. 2 (9) to the opposite side and screw
them in a little.
CAUTION
Risk of injury if hinges fold!
u Leave hinges open.
u Undo screws Fig. 2 (10) and change over the hinges di-
agonally.
The screws Fig. 2 (10) are self-tapping: use a cordless
screwdriver.
u Tighten the hinges.
u Close off the now unused fastening holes with the
plugs Fig. 2 (11) supplied.
u Hang doors on the pre-fitted screws Fig. 2 (9) and tighten
screws.
3.3 Re-attaching the soft stop mecha-
nism*
Fig. 3
u Screw on retainer Fig. 3 (1) .
Changing the door hinges
3