Lowrance electronic X102C - Manual (Page 69)

65
ability to set it anywhere from zero to 100 percent. Once you select a
level in manual, the unit will continue to use that exact sensitivity set-
ting until you change it or revert to auto mode.
To adjust sensitivity in auto mode:
1. Press MENU | ENT .
2. The Sensitivity Control Bar appears. Press
↓ to decrease sensitivity;
press
↑ to increase sensitivity. When it's set at the desired level, press
EXIT . (When you reach the maximum or minimum limit, a tone sounds.)
Left, Sonar Menu with Sensitivity command selected. Right, the Sensi-
tivity Control Bar.
To adjust sensitivity in manual mode
1. First, turn off Auto Sensitivity: from the Sonar Page, press MENU |
↓
to A UTO S ENSITIVITY
| ENT .
2. Press
↑ to
S
ENSITIVITY
| ENT and the Sensitivity Control Bar appears.
Press
↓ or ↑ to pick a different sensitivity setting. When it's set at the
desired level, press EXIT .
To turn Auto Sensitivity back on
From the Sonar Page, press
MENU |
↓ to
A
UTO
S
ENSITIVITY
| ENT | EXIT .
NOTE:
To return to the original factory setting for Auto Sensitivity, see the
entry in this section on Reset Options. If sensitivity is in manual
mode, the Reset Options command will switch back to Auto and re-
set the factory setting at the same time.
Tip:
For quicker sensitivity adjustments, try leaving the Sensitivity
Control Bar on the screen as the chart scrolls. You can see the