LG LP121CEM-Y8 - Manual (Page 27)

14. Connect the condensate pump to the ICR
relay of the terminal of the board as shown
in fig. 40 Make sure to fasten the pump
wire through the wire clip on the back side
of the control barrier as shown in fig. 39
15. Assembly the unit back following the
reverse order of disassembly.
NOTE: All tube should be inserted into rubber
elbows by at least 1/2 inch
- 27 -
Copyright ©2008 LG Electronics. Inc. All right reserved.
Only for training and service purposes
LGE Internal Use Only
Figure 38
Pump
assembly
Tube #1
Tube #2
Rubber
elbows(3)
Spraying
Tube
Figure 40
Figure 39