Linear AE-100 User Manual

Page 27

( B L A N K D I S P L A Y )

U N I T S :

A R E Y O U S U R E ? 5

A C C E S S C O D E :

ALTERNATE PROGRAMMING METHOD

FUNCTION CODE

LOCAL PROGRAMMING

TELEPHONE PROGRAMMING

WELCOME DISPLAY

TEXT

The AE-100 display will show
a visitor a welcome message
alternating with instructions on
how to fi nd and call a resident.
The welcome message can be
customized to suit the installation.

Step 1 Enter Function Code 10, then press #.

Step 2 Enter the new welcome message. A total of 32

characters are allowed. The display will advance
to the lower line after the 16th character is
entered on the upper line. Enter # after each
character, enter ## after the last character.

NOT AVAILABLE

COPY ACCESS

DATA ONLY FROM

MASTER TO

SUB-UNITS

To synchronize programming
in multi-unit installations, the
Directory Entries and Stand-alone
Entry Codes can copied from the
master unit to selected sub-units.

CAUTION: This utility

command will overwrite ALL the
access data in the sub-unit(s)
selected.

Step 1 Enter Function Code 30, then press #.

Step 2 Enter the number(s) (2, 3, and/or 4) of all the

sub-units to copy the data to, then press #.

Step 3 Enter 5 for verifi cation, then press #.

- OR -

Enter

✱ to cancel this command.

NOTE: Function Codes 7 and 8 must be programmed

before this command will operate.

Step 1 Enter Function Code 30 and

press #, one short beep sounds.

Step 2 Enter the number(s) (2, 3, and/or 4)

of all the sub-units to copy the data to,
then press #, one short beep sounds.

Step 3 Enter 5 for verifi cation, then press #,

two short beeps sound. (Any entry other
than 5# will cancel the command.)

NOTE: To allow for multi-unit network

communications, when executing this
command remotely over the telephone,
the system will disconnect your call
after Step #3 then copy the data from
the master unit to the sub-units.

ADD A

STAND-ALONE

ACCESS CODE

A Stand-alone Access Code is
a number entered at the AE-100
keypad to request access. Up to
125 4-digit Stand-alone Access
Codes can be set.

NOTE: Each Stand-alone Access
Code programmed reduces the
possible number of Directory
Entries by one.

Step 1 Enter Function Code 31, then press #.

Step 2 Enter the new 4-digit Stand-alone

Access Code, then press #.

Step 3 Enter the new 4-digit Stand-alone

Access Code again for verifi cation

Step 4 Press #.

Step 1 Enter Function Code 31 and

press #, one short beep sounds.

Step 2 Enter the new 4-digit Stand-alone Access

Code, press #, one short beep sounds.

Step 3 Enter the new 4-digit Stand-alone

Access Code again for verifi cation.

Step 4 Press #, two short beeps sound.

DELETE A

STAND-ALONE

ACCESS CODE

Deletes a single existing
Stand-alone Access Code.

Step 1 Enter Function Code 33, then press #.

Step 2 Enter the 4-digit Stand-alone Access

Code to delete, then press #.

Step 3 Enter the 4-digit Stand-alone Access

Code to delete again for verifi cation

Step 4 Press #.

Step 1 Enter Function Code 33 and

press #, one short beep sounds.

Step 2 Enter the 4-digit Stand-alone Access Code

to delete, press #, one short beep sounds.

Step 3 Enter the 4-digit Stand-alone Access

Code to delete again for verifi cation.

Step 4 Press #, two short beeps sound.