Lowrance electronic Mapping GPS Receiver - Manual (Page 94)

88
The Position Pinning feature was developed so that when you stopped,
the unit locked the present position on the GPS plotter until you moved
a short distance or exceeded a very slow speed.
The command remains available in the unit's software, but we recom-
mend that you leave it in the default off (unchecked) mode. The "wan-
dering" plot trail issue has now been corrected by the Track Smoothing
feature. Turning on Position Pinning could actually result in an inaccu-
rate plot trail if you are moving around in a relatively small area. If you
want to experiment with Position Pinning, the same instructions are
used to turn the feature on (checked) and off (unchecked.)
1. Press MENU | MENU |
↓ to
GPS S
ETUP
| ENT |
↓ to
P
OSITION
P
INNING
| ENT .
2. Press EXIT | EXIT to return to the previous page.
Reset Options
To reset all features to their factory defaults:
1. Press MENU | MENU |
↓ to
S YSTEM S ETUP
| ENT |
↓ to
R ESET O PTIONS
| ENT |
←
to Y
ES
| ENT .
NOTE:
Reset Options does not erase any waypoints, routes, icons or plot trails.
Reset Options command, left,
and the Reset Options Menu, right.
Require DGPS
You can force the unit to require DGPS for reporting a valid position.
(The default setting, off, uses DGPS automatically when an optional
DGPS beacon receiver is connected. However, this auto mode doesn't
require DGPS reception to yield a position.) Here's how to turn manda-
tory DGPS on and off.
1. Press MENU | MENU |
↓ to
GPS S ETUP
| ENT |
↓ to
R EQUIRE DGPS | ENT .
2. To return to the last page displayed, press EXIT | EXIT .