Lowrance electronic Mapping GPS Receiver - Manual (Page 47)

41
Create Waypoint on Map
1. Use the arrow keys to move the cursor to the place where you want
to make a waypoint.
2. Press WPT | WPT . The waypoint is saved and automatically given a
name with a sequential number, such as "waypoint 001." The waypoint
symbol and number appear on the map.
Create Waypoint by Entering a Position
1. Press WPT |
→ to
S UBCATEGORY
column|
↓ to
N EW
| ENT .
2. Press
↓ to
E NTERED P OSITION
| ENT |
→ to
C REATE
| ENT .
3. Press
→ to
L ATITUDE
| ENT . Enter the latitude by pressing
↑ or ↓ to
change the first character, then press
→ to the next character and re-
peat until the latitude is correct. Press ENT .
4. Press
↓ to
L
ONGITUDE
| ENT . Enter the longitude by pressing
↑ or ↓ to
change the first character, then press
→ to the next character and re-
peat until the longitude is correct. Press ENT , then EXIT | EXIT to return
to the previous page display. The waypoint is saved and automatically
given a name with a sequential number, such as "waypoint 001." The
waypoint symbol and number appear on the map and in the waypoint
list.
Navigate To a Waypoint
You can select any waypoint visible on the Map Page with the cursor,
then use the Navigate to Cursor command (we'll describe how later in
this section.) However, you can avoid scrolling the map to pick your
waypoint if you use the Find Waypoint commands:
1. Press WPT |
→ to
S
AVED
| ENT . To look up the nearest waypoint, press
↓ to
N
EAREST
| ENT ; or, to look by name (and scroll through the entire
waypoint list), press ENT . For this example, look by name.
2. If your waypoint list is a long one, you can spell out the waypoint
name in the
F
IND
B
Y
N
AME
box to search for it. (Press
↑ or ↓ to change the
first character, then press
→ to move the cursor to the next character
and repeat until the name is correct, then press ENT to jump to the list
below.)
3. If the list is short, you can jump directly to the F
IND
I
N
L
IST
box by
pressing ENT . Use
↑ or ↓ to select the waypoint name, press
ENT and the
waypoint information screen appears with the G O T O
command selected.
4. To begin navigating to the waypoint, press ENT .