Lincoln 2005 LS - Manual (Page 12)

12 Parking Brake Release
Pull the release lever to release the parking brake. Driving with the
parking brake on will cause the brakes to wear out quickly and
reduce fuel economy. The parking brake is not recommended to
stop a moving vehicle. However, if the normal brakes fail, the
parking brake can be used to stop your vehicle in an emergency.
Since the parking brake applies only the rear brakes, the vehicle’s
stopping distance will increase greatly and the handling of your
vehicle will be adversely affected.
11 AdvanceTrac™ with Roll Stability Control
By monitoring vehicle speed, lateral acceleration, and intended
direction, the AdvanceTrac™ system provides enhanced traction
and stability on slippery surfaces, or in emergency maneuvers.
The system defaults to on. If your vehicle should become stuck, try
switching the system off by pressing the AdvanceTrac™ button on
the center console. When the system is functioning, a yellow icon
will flash.
10 Defrost Windshield
To clear thin ice and fog from the windshield, choose the defrost
mode from the manual override controls; this control will
distribute outside or recirculated air through the windshield
defroster ducts and the side window demisters. To return to
automatic operation, press AUTO.
8 Turn Signal/Wiper Washer Controls
For a single swipe with no wash, tap the end of the stalk briefly.
The bars of varying length are for intermittent wiper operation.
When in this position, rotate the control upward for fast intervals
and downward for slow intervals. For three swipes with wash,
push and hold the end of the stalk. For a longer wash, push and
hold the end of the stalk. The wipers and washer fluid will be
activated for up to ten seconds.
For rear wiper operation, rotate the rear window wiper and
washer control to the desired position. Select INT 2 for normal
speed operation, INT 1 for intermittent operation, or OFF to turn
the rear wiper/washer off. For rear wash cycle, rotate (and hold
as desired) the rear wiper/washer control to either position. The
control will automatically return to the INT 2 or OFF position.
9 Clock
Your clock is mounted on your instrument panel. Press the right
control to increase the time displayed, the left control to decrease the
time displayed.