Life Fitness FIT SERIES - Manual (Page 13)

13
STEP 12:
FIGURE 12
• Route the LEG PRESS CABLE (14) through the MAIN PIVOT ARM (4) as shown, and SECURELY assemble one 4-1/2” PULLEY (16)
to the MAIN PIVOT ARM (4) using two RH CAPS (38), one 3/8 X 67mm BOLT (27), two 3/8 X 1/2” FLANGE SPACERS (23), two 3/8”
SAE WASHERS (35), two 3/8” RH WASHERS (36) and one 3/8” LOW HEIGHT LOCK NUT (34) as shown in FIGURE 12.
• Route the LEG PRESS CABLE (14) between the upper BRACKETS and through the tube on the LEG PRESS FRAME (2) as shown, and
SECURELY assemble one 4-1/2” PULLEY (16) to the BRACKETS using two RH CAPS (38), one 3/8 X 50mm BOLT (26), two 3/8” SAE
WASHERS (35), two 3/8” RH WASHERS (36) and one 3/8” LOW HEIGHT LOCK NUT (34) as shown in FIGURE 12.
• Route the LEG PRESS CABLE (14) out between the lower BRACKETS on the LEG PRESS FRAME (2) as shown, and SECURELY
assemble one 4-1/2” PULLEY (16) to the BRACKETS using two RH CAPS (38), one 3/8 X 50mm BOLT (26), two 3/8” SAE WASHERS
(35), two 3/8” RH WASHERS (36) and one 3/8” LOW HEIGHT LOCK NUT (34) as shown in FIGURE 12.
26 3/8 X 50mm
38
35
36
23
4
2
34
16
27 3/8 X 67mm
14
STEP 13:
FIGURE 13
• SECURELY assemble the swivel end of the LEG PRESS CABLE (14) to the LEG PRESS FRAME (2) as shown, using two RH CAPS
(38), one 3/8 X 117mm BOLT (30), two 3/8 X 1-1/2” FLANGE SPACERS (24), two 3/8” SAE WASHERS (35), two 3/8” RH WASHERS
(36) and one 3/8” LOW HEIGHT LOCK NUT (34) as shown in FIGURE 13.
30 3/8 X 117mm
2
14
24
36
35
34
38
5