Lanier 5618 - Manual (Page 59)

System Settings
User Tools Settings 5 - 3
System Settings
Menu Description
1. Function Priority You can specify the mode (Copier, Fax, Printer) to be
displayed immediately after the operation switch is turned
on or System Reset mode is turned on.
Default: Copier
2. Copy Count Display The copy counter can be set to show the number of copies
made (count up) or the number of copies remaining to be
made (count down).
Default: Up (count up)
3. System Reset The machine returns to its prioritized mode automatically
after your job is finished, after the selected time. This
function is called “System Reset”. The time can be set
from 10 to 999 seconds, or no system reset.
You can specify the prioritized mode with the user tools.
Default: On (60 seconds)
4. Energy Saver Timer The machine enters Low Power mode automatically after
your job is finished, after the selected time. The time can
be set from 1 to 240 minutes.
In Low Power mode, power consumption is reduced by
30% compared with Standby mode. This value applies to
copier features only.
Default:15 minutes
5. Energy Saver Level You can select the Energy Saver level.
Level 1
Power consumption is reduced by about 30%
compared standby mode.
Warm-up time is about 10 seconds.
Level 2
Power consumption is reduced by about 60%
compared standby mode.
Warm-up time is about 15 seconds.
Level 3
Power consumption is reduced by about 70%
compared standby mode.
Warm-up time is about 20 seconds.
These values apply to copier features only.
Default: Level 1