Lincoln Electric IMVERTEC V160-T - Manual (Page 9)

A-2 INSTALLATION
V160-T
A-2
Read entire installation section before starting
installation.
SAFETY PRECAUTIONS
ELECTRIC SHOCK can kill.
• Only qualified personnel should per-
form this installation.
• Disconnect input power by removing
plug from receptacle before working
inside V160-T. Allow machine to sit for
5 minutes minimum to allow the power capacitors
to discharge before working inside this equip-
ment.
• Insulate yourself from the work and ground.
• Always wear dry insulating gloves.
• Always connect the V160-T to a power supply
grounded according to the National Electrical Code
and local codes.
------------------------------------------------------------
SELECT SUITAbLE LOCATION
This machine will operate in harsh environments.
However, it is important that simple preventative
measures are followed to assure long life and reliable
operation.
• Do not place or operate this machine on a surface
with an incline greater than 15° from horizontal.
• This machine must be located where there is free
circulation of clean air without restrictions for air
movement to and from the air vents. Do not cover
the machine with paper, cloth or rags when switched
on.
• Dirt and dust that can be drawn into the machine
should be kept to a minimum.
• Keep the machine dry and do not place it on wet
ground or in puddles.
• Locate the machine away from radio controlled
machinery. Normal operation may adversely affect
the operation of nearby radio controlled machinery,
which may result in injury or equipment damage.
Read the section on “Machine Grounding and High
Frequency Interference Protection” in this manual.
• When operated in ambient temperatures greater
than 40°C, the output duty cycle may be reduced.
• Do not mount over combustible surfaces.
STACKING
The Invertec V160-T cannot be stacked.
TILTING
Place the machine directly on a secure, level surface.
The machine may topple over if this procedure is not
followed.
MACHINE GROUNDING AND HIGH FRE-
QUENCY INTERFERENCE PROTECTION
The Capacitor Discharge Circuit used in the high fre-
quency generator can be blamed for many radio, TV
and electronic equipment interference problems.
These problems may be the result of radiated interfer-
ence. Proper grounding methods can reduce or elimi-
nate radiated interference.
The Invertec V160-T has been field tested under rec-
ommended installation conditions. It complies with
FCC allowable limits for radiation.
Radiated interference can develop in the following
four ways:
1. Direct interference radiated from the welder.
2. Direct interference radiated from the welding leads.
3. Direct interference radiated from feedback into the
power lines.
4. Interference from re-radiation of “pickup” by
ungrounded metallic objects.
WARNING