La Crosse Technology WS-7049U - Manual (Page 13)

13
B. MOUNTING WITH ADHESIVE TAPE
1. With a nonabrasive solution, clean and dry the
back of the mounting bracket and the mounting
surface to ensure a secure hold. The mounting
surface should be smooth and flat.
2. Remove the protective strip from one side of the
tape. Adhere the tape to the designated area on
the back of the mounting bracket.
3. Remove the protective strip from the other side
of the tape. Position the remote temperature
sensor in the desired location, ensuring that the
indoor temperature station can receive the signal.
II. THE INDOOR TEMPERATURE STATION
The indoor temperature station can be mounted in two ways:
• with the table stand or
• on the wall with the use of a wall hanging screw (not
included).
A. USING THE TABLE STAND
The indoor temperature station comes with the table
stand already mounted. If you wish to use the table-
stand all that is required is to place the indoor
temperature station in an appropriate location.
B. WALL MOUNTING
1. Remove the table stand. To do this, pull down
on the stand from the rear and rotate forward.
2. Fix a screw (not included) into the desired wall
leaving approximately 3/16 of an inch (5mm)
extended from the wall.