System setup – Lowrance electronic LMF-400 User Manual
Page 19
17
3. Select
O
N
or
O
FF
and press
ENTER
, which will take you back to the
main display.
4. If you choose to keep the current setting, press
EXIT
to return to the
Audio Setup menu
Adjusting Alarm Sounds:
1. To turn on or turn off Alarm Sounds, select
A
LARM
S
OUNDS
from the
Audio Setup menu and press
ENTER
.
2. Select
O
N
or
O
FF
and press
ENTER
, which will take you back to the
main display.
3. If you choose to keep the current setting, press
EXIT
to return to the
A
UDIO
S
ETUP
menu.
4. Press
EXIT
repeatedly to return to the main display.
System Setup
On each page, the System Setup menu contains, Engine Displayed,
Change Units, Bus Devices, Sonar Alarms, Eng/Tank Configuration,
Reset Values
and
System Information.
To access the System Setup menu, press
MENU
and use the
UP
and
DOWN
keys to highlight
S
YSTEM
S
ETUP
, then press
ENTER
. We’ll discuss
the System Setup menu in more detail in the Advanced Operation
section.
Bus Devices
One of the more significant commands in the System Setup menu is the
Bus Devices command. It allows you to run a system check for all
devices connected to the LowranceNet.
1. To run a system check for devices connected to the NMEA 2000
LowranceNet, press
MENU
, select
S
YSTEM
S
ETUP
and press
ENTER
. Choose
B
US
D
EVICES
and press
ENTER.
After a Searching for Bus Devices
message comes up, a list of all devices attached to the LowranceNET —
the Bus Devices list — will appear.
NOTE:
If you modify settings and are not satisfied with the results, you
can reset the gauge to its factory default settings via the Reset
Values command.
To Reset Values:
1. Press
MENU
, highlight
S
YSTEM
S
ETUP
and press
ENTER
.
2. Scroll down to
R
ESET
V
ALUES
and press
ENTER
. The following message
will appear: Press Enter to reset all values.
3. Press
ENTER
to reset the values.