LG LSC27990TT - Manual (Page 6)

Door removal
Electric Shock Hazard
Disconnect electrical supply to refrigerator before installing.
Failure to do so could result in death or serious injury.
If your entrance door is too narrow for the
refrigerator to pass through, remove the refrigerator
door and pass the refrigerator laterally.
Remove the lower cover by lifting upward, and then pull
up the water feed tube while pressing the release ring
shown in the figure to the right.
Remove lower
cover and
water feed tube
Warning
Remove the
freezer
compartment
door
Remove the
refrigerator
door
Installation
6
1) Remove the hinge cover by loosening the
screws. Disconnect all connections except
the ground line.
2) Remove the keeper by rotating it counter
clockwise and then lifting the upper
hinge up .
3) Remove the freezer compartment door by
lifting it upward. This time, the door should
be lifted enough for the water feed tube to
be completely pulled out.
1) Loosen the hinge cover screws and remove
the cover. Remove connection wire, if any,
except for the ground line.
2) Remove keeper by rotating it clockwise ( )
and then remove the upper hinge by lifting
it up (
).
3) Remove the refrigerator compartment door
by lifting it up.
• If a tube end is deformed or abraded, trim the part away.
Disconnecting the tube under the door causes about
1/2 gallon (2 liters) water to flow
out. Please put up a big container to prevent it.
NOTE
• When removing the upper hinge, be careful that the door does not fall forward .
NOTE
• After removing the door, take it into the kitchen where you are installing the refrigerator.
Lay it down on a blanket and be careful to avoid damaging the water feed tube.
NOTE
Lower Cover
Lower hinge
Lower Hinge
Keeper
Water Feed Tube
Connection
Wires
Connection
Wires
Hinge
Cover
Upper Hinge
Upper Hinge
Keeper
Upper Hinge
Ground Line