Linak TECHLINE LA35 User Manual
Page 12
12
I/O Specifi cations: Motor
I/O Specifi cations: Potential free signal switches
Item
Specifi cation
Comment
Description
Permanent magnet DC motor, available in
12V or 24V
Input Voltage
12VDC, +/- 20%
24VDC, +/- 10%
Cable dimension 2 x 2,5 mm
2
(2 x AWG14)
Current consumption
12V, 2-10A depending on load
24V, 1-5A depending on load
See curves for typical values
Speed regulations
The motor can run with PWM regulation.
This could be used for soft start/stop etc.
The version with “PLC option” cannot be
operated with PWN
Connection
To extend actuator:
Connect Brown to positive
Connect Blue to negative
To retract actuator:
Connect Brown to negative
Connect Blue to positive
See fi gure 1 + 2 + 3 + 4
Use cable 0367002-XXXX
Actuator direction can be operated with
double-throw switch with middle position
“off”
LINAK Code: TR-1939.3314-00
Item
Specifi cation
Comment
Description
The actuator can be equipped with two separate
micro switches that that are activated when the
actuator is fully retracted (IN) or fully extended
(OUT). The micro switches are Normally Open
Input Voltage
10-28VDC
Cable dimension 6 x 0,5mm
2
(6 x AWG20)
Output voltage
Same as input voltage
Switching capacity
Minimum 10 mA
Maximum 1 A
Connection
Supply: Red (Pin 2)
Actuator retracted: Yellow (Pin 5)
Actuator extended: Green (Pin 6)
See fi gure 2 + 3 + 4
Use cable 0367003-XXXX
Combinations
The potential free switches can be combined
with relative or absolute feedback. But cannot be
combined with “PLC/option”
35xxxxx1xxxxxx