Linak TECHLINE LA35 - Manual (Page 7)

7
Misc. on the TECHLINE ® actuator system
Warranty
There is a 12 months’ warranty on the TECHLINE products against manufacturing faults calculated from
the production date of the individual products (see label). LINAK’s warranty is only valid in so far as the
equipment has been used and maintained correctly and has not been tampered with. Furthermore, the
actuator must not be exposed to violent treatment. In the event of this, the warranty will be ineffective/
invalid. For further details, please see LINAK A/S ordinary conditions of sale.
Maintenance
• The actuator must be cleaned at regular intervals to remove dust and dirt and inspected for mechanical
damages or wear.
• Inspect attachment points, wires, piston rod, cabinet, and plug, as well as check that the actuator
functions
correctly.
• The actuator is a closed unit and requires no internal maintenance.
• To ensure that the pregreased inner tube remains lubricated, the actuator must only be washed down when
the piston rod is fully retracted.
Maintenance of spherical eyes
In order to maintain a prober performance of the spherical eyes and to increase the resistances against
hard environmental wear, we strongly recommend that the spherical (ball bearings) eyes mounted on
actuators from LINAK are greased with anticorrosive grease or similar.
Warning!
If irregularities are observed, the actuator must be replaced.