Lowrance electronic X86 TX - Manual (Page 42)

38
Depth Alarms
The depth alarms are triggered only by the bottom signal. No other
echoes will activate these alarms. The depth alarms consist of a shal-
low and a deep alarm. The shallow alarm sounds an alarm when your
vessel enters water that is more shallow than the alarm's setting. The
deep alarm sounds a tone your vessel enters water that is deeper than
the alarm's setting.
Shallow Alarm
To set the shallow alarm depth, repeatedly press
MENU
until
S
HALLOW
A
LARM
appears.
Shallow Alarm menu (left). Shallow Alarm Value Dialog box (right).
Press ↓ to
S
ET
V
ALUE
. The Shallow Alarm Value dialog box will appear.
Use ↑ ↓ to enter the first number in the dialog box, then press
MENU
DOWN
to move to the next digit. Repeat those steps until the desired
depth has been entered in the dialog box. To move the cursor back to
any of the previously entered numbers, press
MENU UP
. Press
PWR
to
return to the Shallow Alarm menu. Use ↑ to select
O
N
, which will turn
on the alarm, then press
PWR
to clear the menu. When your vessel en-
ters water more shallow than the alarm’s setting, an alarm will sound
and a message will appear on the screen.
Press
PWR
to silence the alarm. It will remain silent until it is trig-
gered again.
To turn off the alarm, repeatedly press
MENU
until the
S
HALLOW
A
LARM
menu appears. Press ↓ to
O
FF
, then press
PWR
to clear the menu.