Lowrance electronic X86 TX - Manual (Page 13)

9
If you can, then go to step 3. If it doesn't, repeat step 2, but use a dif-
ferent alignment letter until you can place the transducer on the
transom correctly.
Insert bolt and check transducer position on transom.
3. Assembling the transducer. Once you determine the correct posi-
tion for the ratchets, assemble the transducer as shown in the following
figure. Don't tighten the lock nut at this time.
Assemble transducer and bracket.
4. Drilling mounting holes. Hold the transducer and bracket assembly
against the transom. The transducer should be roughly parallel to the
ground. The transducer's centerline should be in line with the bottom
of the hull. Don't let the bracket extend below the hull!
Mark the center of each slot for the mounting screw pilot holes. You
will drill one hole in the center of each slot.
Drill the holes using the #29 bit (for the #10 screws).
Ratchets
Nut
Metal
washer
Metal washer
Bolt
Rubber
washers